The pages at `https://easyeda.com/cgi/_Cxphdq/` can not be found

BUG

Concise problem statement:

The pages at

http://easyeda.com/cgi/_Cxphdq/

Have been translated to

https://easyeda.com/cgi/_Cxphdq/

but the new link is broken because the pages can can no longer be found.

Can you tell me where they have been moved to?

:)

Steps to reproduce bug:

1.

2.

3.

Results:

Expected results:

Browser:

#Bug Reports#
Bug Reports
URL links to files , updated to V2.6.6, are broken.

BUG

Concise problem statement:

Before V2.6.6, links to files looked like this:

http://easyeda.com/file_view_Voltage-or-current-controlled-resistors_nztLFXewO.htm

They now look like:

https://easyeda.com/file_view_Voltage-or-current-controlled-resistors_nztLFXewO.htm

with https in place of http

However, the new link does not find the target file. Instead, there is a "Page not found message".

There are a couple of examples here:

https://easyeda.com/forum/topic/Time_controlled_switch-wxrlDx1xq

where the links have been updated but no longer work.

#Bug Reports#
Bug Reports
Net corruption in Design Manager?

BUG

Concise problem statement:

In:

https://easyeda.com/editor#id=qoiASa4mE

When I check the V- net in the Design Manager, it shows me that U3 pin 1 is connected to V- (the GND net).

This not what the schematic shows.

What the schematic shows is correct (i.e. it shows what I drew and what I intend) and what the Design Manager says is wrong.

So there must be something getting corrupted.

Can you spot the error?

#Bug Reports#
Bug Reports
Unconnected pin on subpart but cannot see why.

BUG

Concise problem statement:

Unconnected pin on subpart but cannot see why.

In:

https://easyeda.com/editor#id=qoiASa4mE

I have placed two TL084 multi=part devices.

When I run the Design Manager it tells me that U3 pin 11 is unconnected.

I cannot see why: I have moved the device to see if the wire is dragged, redrawn the wires and ground symbol, moved the power pins to a different sub part, deleted and replaced the sub part, checked everything is on-grid but it still reports that U3 pin 11 is unconnected.

The thing that I really don't understand is that it's only pin 11 on U3 that is flagged as unconnected. Pin 11 on U1, the other TL084 is OK.

Can you see what the problem is?

#Bug Reports#
Bug Reports