HC-05 / HC-06 Bluetooth Module: A Practical Guide

Bluetooth continues to be a key wireless communication standard in electronics projects. The HC-05 and HC-06 modules are among the most accessible ways to add serial-based Bluetooth to your microcontroller system. This article walks through their differences, how to use them, and tips for success.

What Are HC-05 and HC-06?

These modules are classic Bluetooth (Bluetooth 2.0 / SPP) interface devices that communicate via UART (serial). They let microcontrollers talk with smartphones, PCs, or other Bluetooth-enabled devices over the 2.4 GHz band.

HC-05 vs HC-06: Key Differences

Feature HC-05 HC-06
Role (Master / Slave) Can be set as master or slave Typically fixed as slave
AT Commands & Flexibility Full command set, allows changing role, initiating connections More limited, simpler configuration
Pins / Features Has extra control pins (e.g. EN, STATE) Basic pin layout (VCC, GND, TXD, RXD)
Best Use Projects requiring dynamic connections or master mode Simpler, single-connection scenarios

If your project requires your microcontroller to initiate connections or manage multiple Bluetooth links, HC-05 is preferable. For straightforward, one-way communications, HC-06 is typically sufficient.

 

Specifications & Operational Data

Typical parameters (varies by module variant):

  • Interface: UART TTL (3.3 V logic)

  • Operating voltage: 3.0 V – 3.6 V

  • Current draw: ~15 mA (HC-05)

  • Signal sensitivity: ~ –85 dBm

  • Default baud rate: 9600 bps

  • Operating temperature range: –25 °C to 85 °C

These details (and more) are covered in the linked documentation above.

 

AT Commands & Configuration

You can adjust module settings (name, baud rate, etc.) using AT commands (text commands sent over serial).

  • HC-05: Enter AT mode (often via a button or pin) and use commands like AT+NAME=..., AT+ROLE=0/1, AT+UART=....

  • HC-06: Uses simpler commands like AT+NAMExxx, AT+PINxxxx, AT+BAUDx for configuration.

Proper line endings (CR / LF) are essential for commands to be accepted.

 

Wiring & Example with a Microcontroller

Basic wiring with an Arduino:

  • Module VCC → 5V (or 3.3V if required)

  • Module GND → Ground

  • Module RXD → Arduino TX

  • Module TXD → Arduino RX

If module logic is 3.3 V, use a voltage divider or level shifter for connections from a 5 V microcontroller. Use a sketch to forward data between USB serial and the Bluetooth module to test communication.

Use Cases

  • Remote sensor data transmission

  • Robot / device control via smartphone

  • Wireless debugging / logging

  • Home automation with Bluetooth link

 

Tips & Troubleshooting

  • Match baud rates exactly, or you'll see garbled data

  • Ensure correct voltage levels to avoid damaging the module

  • Use proper line endings (CR / LF) with AT commands

  • Test simple connections before adding complexity

  • Be aware of signal interference or obstacles limiting range

#Activity#
Activities