Last night I tried to create an 8 pin spice symbol with a PCB pin order of:

1, 2, 3, 4, 5, 6, 7, 8

and a Spice pin order of:

1, 2, 3, 4, 8, 7, 5, 6

After saving to My Parts, I then placed the symbol into a schematic.

Selecting the symbol and pressing the I hotkey, I then found that the Spice pin order of the placed symbol was:

1, 2, 3, 4, 5, 6, 7, 8

I then edited the symbol in the schematic to reset the pin order to:

1, 2, 3, 4, 8, 7, 5, 6.

Saving, closing and reopening the schematic, selecting the part and then doing I again showed that the Spice pin order of the symbol had gone back to:

1, 2, 3, 4, 5, 6, 7, 8

Closing and reopening the symbol in My Parts also showed that the Spice pin order of the symbol had gone back to:

1, 2, 3, 4, 5, 6, 7, 8

Further experiments tonight show that both the PCB and the Spice pin orders reset themselves back to the 1, 2, 3, 4, 5, 6, 7, 8 default sequence.

I did not notice this before the release of V2.x because I made the spice pin order of all the logic devices the same as the PCB pin order.

I found this in EasyEDA V2.4.1 using Chrome Version 41.0.2272.89 (64-bit) and Firefox 36.0.1 in Kubuntu 12.04 64bit.

I haven't tried it on Win7.

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!