BUG

Concise problem statement:
When using the Photo Viewer, any holes that are located in a pad appear underneath the pad.

Steps to reproduce bug:

  1. Place an SMD component or Pad on top layer with no hole.

  2. Place a via in the pad.

  3. View the PCB in the Photo Viewer.

  4. Compare top and bottom layers.

Results:

Via will be shown in the bottom view, but not the top view.

Expected results:

I would expect the top view of the PCB to show a hole/via in the pad. (I'm guessing this isn't intended behavior since I would think a manufactured board would have a hole in the pad.)

Browser:
Chrome

You can see in this picture I have placed a bunch of vias in pad, but they appear to be rendered underneath the pad since I can see the vias on the edges that aren't entirely inside the pad.

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!