BUG

Concise problem statement:

In Photo View,

  1. a hole with a pad on the top side only shows as a hole with a pad round it on the top layer view;

  2. a hole with a pad on the bottom side only shows as a hole with a pad round it on the bottom layer view;

  3. a hole with a pad on one side only is invisible when viewed from the opposite side.

Steps to reproduce bug:

  1. See: https://easyeda.com/forum/topic/Pads_with_holes_on_single_layer_do_not_show_holes_in_photo_mode-EJfVrJDVd

Results:

Holes with no pad around them are not shown in Photo View.

Expected results:

All holes in a PCB should be visible in Photo View.

(After all, they would be visible in a real photograph... :) )

Browser:

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!