I'm not all that new to electronics, but I am new to Spice simulation. Here and there, I get errors from the simulator that say, "no DC value," and refer to a signal generator. The project I am working on now, which is based on a great paper written by John Caldwell, and published by TI, is a pre-amplifier for an electret microphone. Caldwell's paper shows how to simulate an electret with a DC power supply, an AC source, and a voltage-to-current converter. When I simulate his, uh, simulation, it works perfectly. However, when I add the rest of his pre-amplifier circuit, I get the "no DC value" error. This happens even if the pre-amplifier circuitry isn't connected (other than by a common ground) to the electret circuitry. I don't understand that at all.

Here's the project link:

https://easyeda.com/stevensrmiller/Electret_Simulator-gewqI0hbt

And here's the simulation report:

Circuit: untitled

Reducing trtol to 1 for xspice 'A' devices
Doing analysis at TEMP = 27.000000 and TNOM = 27.000000

Warning: vg2: no DC value, transient time 0 value used

Initial Transient Solution
--------------------------

Node                                   Voltage
----                                   -------
xu1.11                                    -nan
xu1.12                                    -nan
xu1.6                                      nan
xu1.7                                     -nan
c2_2                                      -nan
xu1.53                                    -2.6
xu1.54                                    11.6
xu1.90                                    -nan
xu1.91                                      25
xu1.92                                     -25
vcc                                          9
xu1.99                                     4.5
xu1.10                                     nan
c2_1                                      -nan
xu1.13                                     nan
r5_1                                      -nan
xu1.14                                     nan
xu1.9                                        0
xu1.8                                     -nan
v1_+                                        62
vg2_2                                       62
c3_2                                      -nan
r3_2                                      -nan
volprobe1                                 -nan
h.xu1.hlim#branch                          nan
v.xu1.vlim#branch                         -nan
v1#branch                                    0
v3#branch                                 -nan
vg2#branch                                   0
v.xu1.vln#branch                           nan
v.xu1.vlp#branch                           nan
v.xu1.ve#branch                           -nan
v.xu1.vc#branch                           -nan
v.xu1.vb#branch                            nan
a$poly$e.xu1.egnd#branch_1_0              -nan

**********************************************************************************
 Timeout,
 Your simulation results are too large! Try reducing the total simulation time (Stop Time - Start Time), increasing     
 the maximum time step, removing some of your probes or breaking your circuit into smaller simulatable blocks.
**********************************************************************************

I'd be very grateful if someone could help me understand and correct this. Thanks!

#Simulation#
#branchnanv.xu1.vlim#
#branch0v3#
#branch0v.xu1.vln#
#branchnanv.xu1.ve#
#branch-nanv.xu1.vb#
#Simulation#
Circuit Design

No comments yet. Be the first to comment!