Whenever I generate a board file from a schematic, I then start to move the components on it trying to fit my ideas (dimensions of the board, disposition of the components, etc).

Then if I make a small change in the schematic, the only way to correct the board is to correct the schematic first, of course, but then genereate another pcb, having to set all the dimensions and move all the components again.

It would be very very useful if the board file would get updated after a change of the schematic file, maybe with a message notifying it.

I think that this feature would be very useful, in particular for those who are not so practical with an EDA and tend to make several mistake at their first attempt.

#Feature Requests#
#FeatureRequests#
Feature Requests

No comments yet. Be the first to comment!