BUG

Concise problem statement:

Investigating:

https://easyeda.com/forum/topic/Spurious_tracks_in_DRV8825_stepper_motor_driver_carrier_package_causing_DRC_errors-MKDxPvpHZ

has shown that if a right or left drag is used to select the tracks on the bottom solder layer with the All layers and Top silkscreen visibility turned off (i.e. All layers and Top silkscreen invisible) then when the selected content on the bottom solder layer is deleted and the All layers and Top silkscreen visibility turned on again; all the pads and some of the silkscreen text has also been deleted.

Steps to reproduce bug:

  1. Open DRV8825 Stepper Motor Driver Carrier package for editing;

  2. Set the All layers and Top silkscreen visibility OFF;

  3. Set active layer to bottom solder layer;

  4. Use right or left hand drag to select all + crossed traces on bottom solder layer;

  5. Press Delete key (deletes all + crossed traces on visible bottom solder layer);

  6. Set the All layers and Top silkscreen visibility OFF;

Results:

All pads and - depending on extent of drag select rectangle - some or all silkscreen text and possibly the outline as well are deleted.

Expected results:

Expect that only selected content on Visible layer should be deleted.

In fact probably expect that only selected content on Active and Visible layers should be deleted.

Browser:

Chrome

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!