Another Pair of eyes to help please- it may be an importer issue
I am designing a small breakout board for a power supply I am building. this small board will house a few resistors, a usb connector an arduino nano, and a header for supplying juice and other unimportant connections.
Problem: When i go to lay this out on pcb, It appears that a few of the connections in the rats nest are switched.
on the schematic:
- header pins 3 through 10 go to the analog inputs on the nano
- all of the digital pins are supposed to go to the display, excluding the four traces without a resistor.
on the pcb layout named vertical 2.5x1.5:
- d9 and d11 go to the female header for some reason
- thus R5 and R9 are not connected to D9 and D11
- And A5 and A4 are not connected to the Header
I appreciate your time looking over these things and appreciate any help you may provide!
https://easyeda.com/avfinchum/USB_Charger_Breakout_Board-ee6d38f9c70145b9b793b7915ed87323
#PCB#Circuit Design
Sign In Or Register Comment after
No comments yet. Be the first to comment!