Hi guys, I need some advice.

I need to make a PCB where a wire enters from the bottom layer of the PCB and it is soldered at the top layer. I want to solder the wire only at the top layer. The wire would enter from the bottom of the PCB into a hole and the soldered at the top layer.

I saw that Top and Bottom layer are always selected, then a pad with a hole would generate pads for soldering in Top and Bottom. If I change to a via, I the pads for soldering are in green, i.e., they does not allow me to solder the wire after it entered through the hole.

Is there a way to have pads with hole for soldering only in one side of the PCB ?

Regards.

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!