My circuit is too complicated (with QFN flat packages) to do point-to-point wiring, I need Net Port working!

The explanation at https://easyeda.com/Doc/Tutorial/Schematic.htm#Net-Port seems simple enough.

It doesn't work for me... I've tried multiple browsers in both Linux & Windows.

When I "convert project to PCB" and move the QFNs around, there are some rats nets (I think just VCC and GND), but 75% of the pins do not seem to be connected.

There must be some tricks or some gotchas ...

Is there a character length limit or character exclusions to the naming? I see only capital alphanumeric, dash "-" and slash "/" used in the example, so besides capital alphanumeric I'm using some dashes.

Is there a limit to the number of NetPorts? I'm using 8 * 64pin QFN plus other components, so I'm using hundreds of Netports, in fact there is very little other wiring.

Thanks in advance for any help, I've been going nuts for a week and about to give up....

#Schematic#
#Schematic#
Circuit Design

No comments yet. Be the first to comment!