Concise problem statement: for manual soldering, I often increase the pad sizes on the PCB to make this easier. When then updating the PCB with e.g. a pin-remapping from the schematics, all such modifications are lost.

Steps to reproduce bug:

  1. Add Schematic with pads for through hole components 
  2. Change the width/height of the pads 
  3. Add new component to schematic, and use Update PCB

Results: The pads are all reset
Expected results: Settings that can only be configured on the PCB, and not in the Schematic, are left alone

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!