I'm a first time easyeda user wanting to simulate a buck converter circuit. I've constructed the circuit below

https://easyeda.com/editor#id=|aa8c91107b1f45b49f903fce40abef82

When simulating I get the following:

Circuit: gooduntitled

Doing analysis at TEMP = 27.000000 and TNOM = 27.000000

Warning: r9: resistance to low, set to 1 mOhm
Warning: singular matrix:  check nodes u3_3 and u3_3

Note: Starting dynamic gmin stepping
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Warning: singular matrix:  check nodes u3_3 and u3_3

Warning: Dynamic gmin stepping failed
Note: Starting source stepping
Warning: singular matrix:  check nodes u3_3 and u3_3

Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful gmin step
Note: One successful source step
Warning: singular matrix:  check nodes u3_3 and u3_3

Warning: singular matrix:  check nodes u3_3 and u3_3

Warning: source stepping failed

Transient solution failed -

Last Node Voltages
------------------

Node                                   Last Voltage        Previous Iter
----                                   ------------        -------------
u3_2                                              0                    0
u3_6                                              0                    0
volprobe                                          0                    0
u3_1                                              0                    0
gnd                                               0                    0
u3_3                                              0                    0
l2#branch                                         0                    0
v1#branch                                         0                    0

doAnalyses: iteration limit reached

tran simulation(s) aborted
Error(parse.c--checkvalid): volprobe: no such vector.
ngspice-26 done

I used the design manager to check connections and node connections. I can't spot anything wrong so I am uncertain as to how to fix this error? Is it possible that the LM2678 switching ic used here does not have a spice model available for simulation?
Any help would be greatly appreciated.

#Simulation#
#branch00v1#
#Simulation#
Circuit Design

No comments yet. Be the first to comment!