Simulation of simple circuit with AC sweep
Hi,
I would like to simulate the frequency response of an experimental circuit that I use but I need some help.
The circuit is composed of a tunnel junction of impedance Z=16000 Ohms that is linked to a RF electrical source (50 Ohms) through coaxial 50 Ohms wire (around 5m ).
The story is that this tunnel junction is emitting light, and when I sweep the AC voltage applied to the junction from 20MHz to 350MHz, I observe regular peak in the light intensity, spaced by 45 MHz. I think that this phenomenon is caused by mismatch impedance. The electrical power feeding the junction to emit is function of the frequency. I assume that the impedance of the junction isn't constant because of its IV caracteristic, but a constant impedance could be a good begining.
I would like to confirm my interpretation with a simulation but I don't know how to simulate this. I tried but it difficult for me to observe the result with WaveForm.
the project link that I did: https://easyeda.com/mickael.buret2121/tunnel-junction_simu
Result from APD measurements (peaks maybe due to the non linear response of the tunnel junction because of the IV caracteristic)
Sign In Or Register Comment after
No comments yet. Be the first to comment!