Hi all\, I'm some way through my latest design and have during the process have deleted and relaced some components to make things fit onto the board.I need to assign a specific design rule to some of the nets so the have greater spacing and wider track. So far so good\, however when I open the Design Rule dialog box some nets are missing from the list. Oddly there is a 5 pin connector\, J2 with pins labeled 1 to 5 and only pin J_1 is in the net list\, where are pins J_2 to J_5

Edit,
Panic over, I found them labelled by the component at the other end of the net. Doh!

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!