I created a custom component with two pads and then used routing to create the pcb trace.

Title: 13.56 NFC 40X40 ANTENNA

https://easyeda.com/component/e42a6e232e4a4babab2e6fcd8f6d12d1

However, when I use it in my PCB design it fails a DRC check at the pads, saying that it fails the clearance check. (note that for my DRC check I changed the vias size check to 8mil for hole).

So, as I am still fairly new to easyeda, I am wondering what is the best way around this.

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!