Copper area won't fill.
I'm very new to EasyEDA and PCB design in general, in fact, this is my first time. So I am sorry if this is a stupid question but I am pulling my hair out over it.
The goal of this PCB is to take the 3.3v data signals outputted from a NodeMCU, route them through two Logic Level Converters and pass the new 5v signal to some screw terminals (P7 and P5). I have all of the tracks drawn, there are no DRC errors, but I can't get the top and bottom copper areas to draw. I didn't start with a schematic, I just went straight to laying out the PCB. Attached is a screenshot showing my layout, the copper areas defined, but no copper areas drawn. Is it because I am not using a copper area as a GND plane?
Thank you to anybody that takes the time to read this and offer any advice.
Sign In Or Register Comment after
No comments yet. Be the first to comment!