Okay, on a more complicated circuit I accidentally had a probe on a wire that was connected to ground, but kept getting the message"Probe can not connect with ground (GND)!". So I kept moving it closer to ground with fewer and fewer components. Finally realized its the error message that is misleading and incorrect.

https://easyeda.com/editor#mode=sim\,id=c12f25b311704912bee3a904b35132d9|134d7ad7409345c280a0efab414bd2f2

After reading the Simulation eBook https://docs.google.com/document/u/1/d/1OWZVVFRAe_2NW3WratpkA_SGuHa5AcRow5ZRfvcoVTU/pub#h.1y810tw (following advice on the Posting a Question sticky on the forum) under Probing Voltages, it states:

>In spice simulations\, all voltages are referred to ground so not only is there no need
to attach a Voltage Probe to the ground net, in fact doing so will throw an error in the simulation.

..but is the same error being returned for "no connect to ground" as "connected to ground"?

Also, fyi, the first tutorial listed in the page below is returning a 404 error. @andyfierman
https://easyeda.com/example/Simulation_Quickstarter-iLN8usOaw
https://easyeda.com/example/Spice_tutorials-AysKEWevN

#General Discuss#
#GeneralDiscuss#
Others

No comments yet. Be the first to comment!