AC Analysis is broken because "AC 1 0" is being incorrectly appended to ALL Voltage sources ignoring how they are configured in the schematic.

This is an example simulation but all simulation netlists I have looked at recently show the same bug.

https://easyeda.com/editor#mode=sim\,id=|8aae27aaf8d64096b407367892960681

Adding "AC {amplitude} {phase}" to a voltage source enables it to be used as the signal source for an AC Analysis and normally it is this source and this source only that is then used for creating a Bode or frequency response plot. There are occasions where more then one source may be used but that is very unusual.

  • The choice of which source to append "AC {amplitude} {phase}" to has to be left up to the user and MUST not be automated. In particular it must NOT be appended in such a way that the user cannot see or edit it!
#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!