I'm trying to lay out a HAT for a Pi and wanted to use some solder jumper to make CS and IRQ lines configurable with a default.

sample project: https://easyeda.com/beikeland/solderjumper-test

JUMPER-PAD-2-NC_BY_TRACE
and
JUMPER-PAD-2-NOYES_SILK

was selected as they came with or without a trace to close the gap - but this confuses the autorouter and design rules as I can have two different net names on both cases, and even if I use the same net name for the NC one it still is confused. Are there other jumper parts that allows a me to use different net names with a default closed or will I need to use an open and hope a solder paste layer will form the bride and also place them on the layer I want assembled?

image.png

image.png

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!