Hi Folks,

I am a newbie to PCB design working on my 3rd project with each one getting progressively more complicated.  I am hoping that someone can steer me in the right direction to debug some issues I am having.

I am getting the following error on 3 nets when trying to create my gerber file:  "Incomplete connection, please check."

Unfortunately, the message is a bit vague so I am not sure about the root problem with each of the nets.  I have recreated them several times to no avail.   The project is published at https://easyeda.com/mtroyer/esp8266-pir-temp-battery-board.

Any tips on resolving these 3 net issues is greatly appreciated.  Also, appreciate any design tips in general!  My forte is software/firmware programming but I am really enjoying this learning process.

thanks,

Mark

image.png

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!