Im not sure what im doing wrong but I seem to be having trouble with my board layout when trying to convert a schematic to PCB. The board is mostly a pass through with a few passive components in between. The trace should go from pin 15, through a capacitor, then a resistor, and back around to pin 13.  The same setup is also on pins 11/9 & 7/5.

However when i convert to PCB the designer bridges pins 13/15 and sends the trace through the capacitor/resistor without going back around.  Is there a way to run the track manually? When i try to override it in the PCB editor it wont let me connect the tracks.

https://oshwlab.com/capsulej/rgb2

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!