Hello All!
I'm new to pcb design and want to confirm the correct way to limit copper area/fill.
I have a simple pcb with 2 nets/no components as per attached image.
The inner circle/track with 18 pads is 1 net and rest of the board is the other.
Pads are plated through so bottom layer is the same.

The only way I found to keep the clearance between the nets while at the same time maximizing
copper between the 18 holes on the outer net was by adding a thin circle with 3. net attribute and sizing/hiding it under
the track that has the outer 18 pads.

Is this going to make trouble/confusion fabrication?
Is there a better way to achieve this?

Thank you in advance,
Koep
pcb.JPG

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!