Do I need to add pads for components?
Hi all: this is my first post. Congratulations for the superb community and all the knowledge that you have gathered here!
I am designing a PCB for a quadcopter based on an Arduino 2560 MEGA PRO, which receives data from several sensors. After finishing it, I showed it to a (not very friendly) local hobbyist and told me I hand't added the pads for the components. So, this is my big doubt: all the footprints include pads. Since I wil be soldering them after receiving the PCB, do I need to add the pads to the board itself, or is it enough with the ones the footprints contain?
Also, would you please take a look at the PCB design before I send it to fab? I've read on best practices and I think I've followed them: ground plane, no copper under the NRF24l01 antenna, trace width and separation, etc.
The project can be found here: https://oshwlab.com/jluquedz/quadcopter/
Thank you very much in advance.
Javi.
Sign In Or Register Comment after
No comments yet. Be the first to comment!