The PCB Looked Finished Until I Opened the Gerber Viewer

There have been a few times when I thought a PCB was ready for manufacturing, only to notice small issues after opening the Gerber Viewer.

Nothing, maybe a silkscreen too close to a pad, a forgotten board label, or a copper pour that didn't look the way I expected.

Since then, I've treated the Gerber Viewer as one last pair of eyes. Even if the layout looks fine inside the PCB editor, I still like to check the manufacturing output before sending it out.

A few extra minutes is worth avoiding another PCB revision.

#JLCPCB# #EasyEDA# #PCBLayout# #Gerber# #PCBDesign# #Electronics#