Good evening, I am doing a project in which I want to measure air quality. I started the project with the ESP8266 NodeMcu board and three sensors, temperature (DHT22), VOC's (CCS811) and PM (PPD42).



I have it all assembled with a breadboard and the NodeMcu and it works fine.



The fact is that I want to pass it to PCB and I am a little lost. From what I've been reading, I have to use the same board but without NodeMcu, so I use ESP12-E.



I have tried to make a design, (I attach images). I copied the connections that I already have working on the NodeMcu and grouped all the GND connections in a single point.



Schematic



The 3V3 pins I still have no idea how to do it, if anyone can give me a hand I would appreciate it.



Also I do not know if the connections are good, since the NodeMcu has several components and I do not know if I have to put them here too, I am very new, if someone could confirm that the connection is correct I appreciate it.



Am I wrong or am I on the right track?



Thanks a lot! (::

#Schematic#
#Schematic#
Circuit Design

No comments yet. Be the first to comment!