Hello,
I am new to EasyEDA. I have had a go at creating my simple circuit I would like to print.
A few issues I have not been able to get past, before I add the traces:
My project is here : https://easyeda.com/editor#id=5d1a3eaff18249d3a87c46eec56cec60
I would like to add three pads for connecting the power wires : Vcc Low, Vcc High and Gnd - how to add these? In the schematic or in PCB layout and connect them to the voltage regulator?
Many thanks in advance,
Al
#PCB#Circuit Design
Sign In Or Register Comment after
No comments yet. Be the first to comment!