Pretty new to EasyEDA. Sorry in advance I am not the best at explaining things. I'll do my best...

I will say first that sometimes when drawing a wire, it stops at the edge of the center of the pin/connector. Can someone tell me why that's happening? I tried drawing a wire to an LED that I had previously placed a wire on with no issue. Both on the same (bottom) side of a 2 layer board. Then the little yellow "X" appears. I had manually moved the wire to the center of that LED pin myself.

When using the menu Design > Check DRC, it shows 4 errors:

2 "Clearance (Track - Track)" and 2 "Clearance (Pad - Track)" errors.

The bottom of the screen gives a note on the error:

"The clearance between two object is less than the Design Rule Checking (DRC) clearance with has different nets."

I am not exactly sure what that means.

I have attached an screenshot of the error.

Thanks in advance for any help!

Mike

ACL40 Error.png

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!