I have been using Autoroute and it has been working fine but I don't want to have to change with of certain routes every time I re-route the board.  I was able to overcome this on most I am concerned with by adding Net Flags but the green nets coming out of my relays I would like the be a thicker width when I autoroute.  Other than manually finding each route in the table is there any way to do this on schematic or some other way?  Thanks

PS: on another note, should I be adding any type of diodes on my 24vac lines to the relays from connectors?

nets.jpg

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!