If I set the grid and the snap to 0.05mm, when I hover the mouse over the first few grid points the coordinate match up but once I'm 45mm across the coordinates are now snapping to 45.011.  This is highlighted by the PCB outline point being on 45mm but not matching up to the grid.
Origin:
image.png
45mm point:
image.png

Is this a known issue?  It is a bit of a nightmare once I start modifying a part of the PCB outline as the new part snaps to the grid.

thanks,

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!