Hi,

I'm new. I have a single schematic but in the final result I need to cut the PCB in two, connected together in 90 degrees. I was reading others topics about this but I'm not sure what is the best way to do it without penalization.
Can I send my PCB with a slot or board cutout like this?
Cut with board cutout



OR the best way is with a Top/Botton Silk line:
Cut Top/Botton Silk line

It is only PCB fabrication without SMT service.

Thanks

#General Discuss#
#GeneralDiscuss#
Others

No comments yet. Be the first to comment!