I have a need to attach a wire to a PCB. My footprint produces a plated slot on the edge of the board that the conductor bundle is dragged into, retained in the slot, soldered then the extra wire trimmed. This is a lot easier and quicker than trying to poke the wires through a hole. If the insulation is stripped and the conductor only bared for  a few mm the bundle is restrained by the insulation that is discarded after soldering.  wire term 3D small.jpg.wire term footprint small.jpg
The footprint has a solid copper region  around the pads. When I attempt to rout to the footprint, I cannot get out of because I assume the copper has not assumed the netname of the pads.
How do I declare the net of the copper within my footprint?
Peter Clark, Bendigo Australia

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!