Suppose you want to put some pads on the PCB to solder wires into.

  • Rule 1: If it is on, or forms an integral part of, the PCB then it must be in the schematic.

So put one or more symbols for these connections into the schematic, assign a suitable footprint to the symbol(s) then do Update PCB.



Assume that you want to connect N wires:



Here's how:

  1. Search the Library for a Footprint for a connector with N through-hole pins having a suitable hole diameter to accept the wires you wish to solder to the board; 
  2. If you cannot find a Footprint for a suitable N pin connector then try searching the Library for a Footprint for a single through-hole (Multilayer) pad with a suitable hole diameter to accept the wire you wish to solder to the board;
  3. If you cannot find a suitable Footprint then you can search for a similar one, clone it and edit it to suit your needs;
  4. If you cannot find a suitable Footprint to modify then you can create your own to suit your needs;
  5. Note the name of whichever Footprint you find, modify or create; 
  6. Depending on what Footprint you have found or created, find and place a Symbol for any N pin or a Symbol for any single pin connector into your schematic;
  7. Set the Symbol's Convert to PCB attribute to Yes;
  8. Set the Symbol's Add into BOM attribute to No;
  9. Click on the Footprint attribute of the Symbol and using the Footprint Manager, assign the Footprint name that you noted in (5) above to the Footprint attribute of the Symbol; 
  10. You can ignore or delete any Supplier and Manufacturer information (because it's just a pad on the PCB); 
  11. If you have used a Symbol for a single pin then copy it (N-1) times to make up a total of N instances in the schematic;
  12. Wire up the symbols as required in the schematic;
  13. Save the schematic; 
  14. If this is the initial creation of the PCB, do Convert to PCB... in the Schematic Editor otherwise, do Update PCB... in the Schematic Editor or Import Changes... in the PCB Editor;
  15. Place the Footprints where you want them in the PCB.
#Skill#
#Skill#
Circuit Design

No comments yet. Be the first to comment!