I'm designing a board with an edge connector for 805 series female sockets.
Normally these have a bevelled / chamfered edge to allow for easier insertion.
Screenshot 2022-06-24 111250.jpg
I have seen a few other threads talking about this for PCIE cards, suggesting using v-cuts to produce a snap off edge that leaves a similar result.

I know JLCPCB can do this for panelised boards, but is it possible to add a v-cut to an 'un-panelised" board?

#PCB#
#PCB#
PCB

No comments yet. Be the first to comment!