inner layers are positive film pattern
I used the "one click" method in EasyEDA Pro to order a PCB + Assembly from from JLCPCB. Here is my project: https://oshwlab.com/carlk3/rp2040-sd-card-dev. I got a question from Susie at JLCPCB:
As shown below, it seems that the inner layers are positive film pattern.
Is that Ok to proceed per file directly?
...
I'm not really sure what's going on here. In Layer Manager, I have:

I read about the "Negative film effect" in the EasyEDA Pro Tutorial, but it's not clear to me how to switch it from positive to negative. My intent is to have (mostly) solid Power and Ground inner planes.
In general, is there any real difference between a "Plane" type inner layer and a "Signal" type with a copper pour? One is negative film pattern and the other is positive? Is the end result the same?
I'm not trying to do anything tricky or unusual here. I just want a normal 4-layer board with power and ground on the inner layers. It sounds catastrophic to accidently swap positive and negative film patterns! How should I proceed?
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!