JLCPCB supports two different designs on one PCB. Question is what's the best way to achieve this using EasyEDA ?

I've got a receiver and transmitter module. Design is relatively similar other than 5-6 components that needs to be replaced. I tried to create a second panel using board outline and place second schematic in that, but that doesn't help. Since the net-names are the same I start getting rat-lines across the boards.

How can I create two independent schematics and place each into a separate panel on the same PCB ?

Thanks a lot,

Ali

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!