I have reluctantly switched over to the Pro version and I am finding that it not very intuitive as the Standard version.

For example, adding and then editing components in the Standard version was ever so easy. I simply clicked on the thumbnail and it would open up on my browser.

This is not the case with Pro.

This is what I have discovered so far.

I have just imported a component into my Pro version. I did this by first exporting both the schematic and the footprint from the Standard version and then I combined these files in a zip file before selecting these to import in Pro.

However, now it is not so clear. I had to first click refresh to see my new imported component. Shown in the image, I can see in "Device" table that it lists a Device and a Footprint.

image.png

If I then click the "Symbol" tab it shows me:
image.png

But if I click on "Footprint" it is blank - so where did that footprint go?
image.png

Now, if I go back to the Device Tab, I can find no obvious method to edit my component. Why is this so difficult to find?

I also then want to add in a 3d model to my component. In the Standard version this was very easy, but in the Pro version I cannot find a similar method.

#Skill#
#Skill#
Circuit Design

No comments yet. Be the first to comment!