Hello!

Here you can find an example circuit. AMP11_NI is an op-amp input that is connected between an H1-1 pin and a 33mOhm resistor. I would like to have two different design rules here. A wide line should go from H1 to the resistor because it should carry lots of current, and a thin line should go to the op-amp. I'm using a 0Ohm resistor to divide these lines into two different netlists, but these resistors are quite bulky. Maybe anyone knows a more elegant solution?

Screenshot 2023-08-25 145222.png

Thanks!

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!