I have a PCB with 6 layers:

  1. Top Layer with a GND Copper Region
  2. Layer 3V3 (Plane)
  3. Inner2 (Signal) with a GND Copper Region
  4. Layer 5V0 (Plane)
  5. Inner4 (Signal) with a GND Copper Region
  6. Bottom Layer with a GND Copper Region

How can I create a Design Rule, so that Auto Routing automatically creates a Via to the plane for the Nets: GND, 3V0 and 5V0 if the routing has a certain length?

The expected result would that Auto Routing takes this image:
before.JPG

And routes the Nets GND, 3V3 and 5V0 with Vias like this:
after.JPG

Is what I am asking even possible, anyone care to give an explanation of how a design rule like this may be set up?

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!