How to design high current routes?
hey
im a little bit in struggle to design high current routes.
i have a mosfet, that should "waste" 300W (up to 30A) in an electronic load. i can design it with 6mm tracks, but this is not enough, so i tried to spread out the copper area in the same net, to make the track bigger. but its sooo messy to make it look nice - and i dont know, if its capable of doing this current.

Q1 is the mosfet, R4 the currentshunt. the VDUT connectors cant be near. because of the cooling solution. (AM5 PC Water Cooler)
So i tried to make the tracks as big as i can, but 2 things are wierd. how to i manage that "bigger" tracks better? now i have hundreads of seperate polygons or rectangles, but i cant make them as ONE track. and the 2nd problem is: how big must the track be, to drive 20A? I think its 1-2oz of copper plating.

i want to use the bottom layer too for that tracks, so i can via them later, but my struggle are the copper areas and the current limit of them.
any help would be nice
Chris
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!