Simulation VaveForm Config
is it posible to set a stament in the Scematic that manipulates the configuration of the WaveForm window?
example, i can run a simulation,
go to the WaveForm window that apears,
on the menu i can go to WaveForm / WaveForm Config
then display a given value in a seperate grouph
screenshot example attached
but i have to do that every time i press simulate
my question is, can i add some kind of "DOT" statment to the scematic that will configure the WaveForm that is displayed at the end of the simulation without having to re configure it repeatadly every time i press simulate

Circuit Design
Sign In Or Register Comment after
No comments yet. Be the first to comment!