Hello, I am new to EDA and have never ordered a board.

 

I am building a PCB that has a Raspberry Pi Pico WH on it. However, I don't want the footprint of the board to be holes. I would instead like it to be a set of 2 1x20 female 2.54 pin sockets. 

 

So I can easily just build a custom footprint that has the desired spacing and holes. What I'm worried about is whether or not I can specify to JLC that I will need 2 pin sockets for this single footprint.

 

If anyone has experience with this, I would really appreciate it

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!