Ratline highlight colour in EasyEDA PRO.
Hi. When I mouseover a pad, the associated ratline (net) and any other pad also connected to the same net also iluminates as below:
(Pad 2 of C3 as well as pad 12 of U2 change colour)
This is great as it shows where I need to connect a trace to. However, if I am in line draw mode ( [ALT] + L ) the pads and ratline don't iluminate so it is difficult to see where I need to run the trace.

In the above image, while I'm drawing the line, pad 12 is not iluminated and the ratline doesn't follow the new trace as I draw. When there are fine pitch pads on high pin count devices or the trace runs a long way, it is difficult to see where it needs to go to.
With EasyEDA std, the ratline and pad lights up much more (bright white)

Additionally, when I draw the trace, the ratline follows the end of the trace and is bright white. It's much easier to see where the trace needs to connect to especially if there are lots of ratlines or fine pitch devices.

Is it possible to configure EasyEDA Pro to function the same way as EasyEDA Std or should it be a new feature request. I think EasyEDA Pro is a much more advanced software but I've found it a little more difficult to do board layout compared to EasyEDA std due to the ratline/pad colour not changing while in line draw mode.
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!