automatic solar tracker
Design a schematic for an Automatic Solar Tracker using analog LDR sensing and H-bridge drive.
Requirements:
- Two LDRs form a light-difference sensor with 10kΩ resistors as voltage dividers, separated by a vertical fin.
- LM358 dual op-amp (single-supply) used as:
1) Comparator to detect which LDR is brighter.
2) Inverter/buffer to generate complementary direction.
Add small hysteresis (~100k feedback) to prevent motor chattering.
- L293D motor driver controls one DC BO geared motor. IN1 gets the comparator output, IN2 gets the inverted output. EN1 tied high. OUT1/OUT2 go to motor.
- Power: 3.7V Li-ion battery charged by TP4056 module from a 5V solar panel.
- Provide a regulated 5V rail for logic (L293D VCC1 and optional sensors) using a step-up converter (e.g., MT3608) from the 3.7V battery OR suggest using a 5V boost block. Motor supply (L293D VCC2) can be battery (3–6V) as available.
- Add a main SPST power switch.
- Optional: two NC limit switches in series with motor leads to stop at end positions.
- Include decoupling capacitors: 0.1µF near LM358 and L293D, plus 100µF on supply rails. Common ground everywhere.
- Label all nets and pins clearly: VBOOST_5V, VBAT_3V7, SOLAR_5V, LDR_A, LDR_B, DIR_A, DIR_B.
Output: clean schematic in one sheet with component values shown.
#Schematic#
Sign In Or Register Comment after
No comments yet. Be the first to comment!