(I'm unsure if this is a question about the schematic editor, the PCB editor or either/both.)

I have a design I want to send to JLCPCB. I want two of the components to be not fitted — not in the BOM, not in the solder stencil, not in the pick and place. Ideally not in the 3D renders, either. How do I achieve this?

I found the "Add into BOM: no" option in component properties in the schematic editor. It greys the component out in the schematic and excludes it from the BOM, but it still turns up in the pick and place. (I did try "Import Changes from Schematic" and it did carry the setting forward from Schematic to PCB editor, but that didn't help.)

I've found this forum entry, but:

  • It's eight years old
  • The image attached to the response seems to have gone missing
  • I can't figure out how to set "Mounted as NONE", or even if that's still a valid answer in modern EasyEDA

Any help greatly appreciated!

#Others#
#Others#
Others

No comments yet. Be the first to comment!