The overall project goal is a one-time, self-latching controller called “VORTEX Powered by AVS.” I want the board to power up in a guaranteed safe OFF state with the output completely disconnected (no current can flow even if there is noise, floating pins, or a momentary power glitch). After power is stable, a single short trigger pulse (button or signal on J1 lasting ~0.25 seconds) must instantly latch the system ON forever with no way to turn it off except by removing power. The latched ON state must drive both a red status LED and turn on the low-side MOSFET switch so the external circuit on the output connector (labeled OUT) fires and stays powered continuously until the battery is disconnected. I specifically want the TLV809EA29 voltage supervisor to hold the flip-flop’s CLR# low for its full delay at power-up so the Q output stays low (OUT = 0 V). Then, when the 2N3904 pulls PRE# low, the flip-flop must set Q high and latch it permanently even after the transistor turns off. The latched high Q must light the red LED and drive the IRLML6244 gate high so the MOSFET pulls the OUTPUT “–” pin to ground while the “+” pin is tied directly to VCC, completing the circuit. I also want the green power LED to show the board is alive from the moment VCC is applied, and I want clean decoupling, proper trace widths on the output path, and a 2-pin header that supplies switched ground on pin 2 with VCC on pin 1. Does the submitted schematic and PCB layout achieve exactly this behavior? Please confirm that every part matches what I described or if anything is missing or wrong.

#Schematic#
#Schematic#
Circuit Design

No comments yet. Be the first to comment!