If there are duplicate reference designators in a single or multisheet schematic, when it is to be passed into PCB layout then an error message is shown.

The user sees a similar error message when running a simulation too.

Running the Schematic Design Manager also show an error message.

Suppose for example there are three resistors labelled, R3.

Using:

Super Menu > Miscellaneous > Find Component... > R3

it is only possible to find the first instance of R3.

To find the second instance the reference designator of the instance of R3 that has been found must be changed to R?.

Running:

Super Menu > Miscellaneous > Find Component... > R3

again will then find the second instance.

To find the third instance, the reference designator of the second instance of R3 that has been found must also be changed to R?.

Is there a way to improve or automate this process?

#Feature Requests#
#FeatureRequests#
Feature Requests

No comments yet. Be the first to comment!