Overlapping/Nested copper area not working properly
EasyEDA Standard v6.5.51 I have created a copper area on my top layer with net GND. I've also created another copper inside this with net NET2. For both nets, I have connected pads and vias. But despite rebuilding my copper areas, the GND area completely fills the PCB as if the NET2 copper area isn't defined. What am I doing wrong? #PCB#
Incorrect Package for C158100
LCSC indicates the package as 0603, but when imported to EasyEDA, the package used is LED-SMD-1.7X0.6-F #GeneralDiscuss#
Rotate component, prefix silkscreen doesn't rotate properly
When rotating a component, the component's prefix/reference is not rotated as expected. Steps: 1. Place a component and move and rotate the prefix/reference. 2. Now select the component and rotate it 3. The silkscreen text is now rotated and offset to an incorrect position and orientation than expected. Before After rotating once. #PCB#
Copy-Paste: Prefix Display off ignored
When you copy and paste a component in PCB layout and the component's "Prefix Display" is set to "No", the pasted component will display it's prefix and the property value will be changed to "Yes". #PCB#
Incorrect Footprint for C34677/HY951180A
Hi, The footprint (RJ45-LIGHT-90) for LCSC Component C34677 is incorrect according to the datasheet. The spacing between the LED pins (pins 12, 11, 10, 8) is 2.54. The incorrect value (11.43mm) was used in the design of the current footprint. 11.43mm refers to the spacing between the plastic locating pegs. This is the current footprint And this is what the datasheet says it should be Finally, here is a product picture showing the spacing for the LED pins. #GeneralDiscuss#