Integrated Pro Micro Issue - Windows Error
Hi guys! I came here a while back for help arranging a PCB which had an integrated Arduino pro micro 5v. This was so I didn't have to solder on an actual pro micro onto my PCB! I took the schematic of a pro micro 5v and I merged that with my current schematic which was really simple a few switches and an encoder. Now I did the PCB design and got everything joined up and in place and bit the bullet and had a few made! However today I received them, soldered on my USB-C port but it is not being picked up in windows, or if it does it says there was a problem with the device! One thing to note is that LED1 does light up solid, and shorting the reset pads does disconnect and reconnect sound in windows but it still is not recognised. Now in terms of the USB-C, on the schematic I used a SHOU HAN C668624, but the actual part I soldered on was a DX07S016JA1R1500 but the pinout seemed to be the same? Now if that port was not the issue I cam hoping someone with a bit more knowledge could spot the mistake I have made in my schematic D: https://oshwlab.com/AKiwi92/macro-pcb_copy Looking for a little direction on what I have done wrong! Hoping if there's something connected wrong I can cut traces / jump something to get it debugged and working! Thanks! Ash #Schematic#
First Schematic Sanity Check - And PCB Advice
Hi guys, So this is my first PCB/Schematic in EasyEDA, I have been trying to make a PCB for a 6 key and 1 rotary encoder macropad using a pro micro that will be running QMK. I was going to use JCLPCB to make the board and solder all the SMD components on the back, I would solder on the USB_C and rotary encoder. I have gone down a hole from soldering a pro micro on there, to actually building a pro micro into the design so I can have a centrally aligned port and change it to USB-C (Just 2.0). Can anyone advise if my schematic looks right? And the PCB I have started I have had to take a break as it is getting way too complex and I am struggling to make everything fit/connect! I am now thinking can I just SMD a pro micro on the back in a central position that won't affect the through pins of the switches? Feeling a little overwhelmed at the moment! https://easyeda.com/AKiwi92/macro-pcb_copy Cheers, Ash #Schematic#