PCB layout doesn't fully erase components
Hi, i placed a schematic module and PCB module. Since I placed them at a consecutive order its annotation was coherent (components annotation was same on both schematic and pcb layout). in a certain point I placed a PCB module and then erased it from PCB layout. The next PCB module was numbered as if the previous module (the one that i previously placed) is still exist. so when updating he PCB, lots of unnecessary components were added and routing issues appear. is there a way to solve this issue? thanks, Ahiad #BugReports#
Trouble with indexing pcb components
Hi, i am working on a big project. where i need to duplicate 16 times the same circuit into one big circuit. in order to do that i created a schematic module and pcb module corresponds to a single circuit. i place each pcb and then placed the suitable schematic module and since it had the same indexes it connected it properly. at certaing point i modified the pcb module, and from that point when i place module on schematic and on pcb and then i do update pcb it is create some irrelevant components and does not create connection as in the schematic. does anyone knows what to do? Ahiad #PCB#
Annotation when placing 2 of the same module
Hi, i have a module consist of 2 op-amp. these 2 op-amps are packed in one component so when placing them it appears as U1.1 and U1.2. When i place another module i would have expected it to annotate the component as U2.1 and U2.2 respectively but instead it annotate as U1.3 and U1.4 and it messes the PCB layout routing. is there a method to solve this without manually change the annotation? so if i add more than 2 components it will keep annotate it correctly. thanks, Ahiad #Schematic#
How to avoid duplication in PCB layout
Hi, I have a PMT (a component) that has 16 output channels. all channels has the same circuit for filtering the signal - which means the same circuit is duplicated 16 times. is there a method i can create the layout for only 1 channel and duplicate it to all other channels instead of manually locate each component? i defined one channel's schematic as a module but i couldn't figure out how to create its own PBC - i am not sure it is even possible to do it that way. thanks, Ahiad #Skill#